Publicité
Les langues disponibles
Les langues disponibles
PREPARATION - BEFORE INSTALLATION:
1. This product should be installed with proper installation tools.
2. Install this product while observing all warnings and precautions
stated in this instruction booklet.
3. VERY IMPORTANT: Thoroughly wash vehicle with Soap and
Water.
4. Parts storage should be flat at room temperature and in a clean
dry place. Care should be taken to avoid a dusty environment.
Exterior Graphics - Side
1 Alcohol
Thoroughly wash vehicle with a soft lint-free cloth. Wipe the panel
where the Exterior Graphic will be installed with alcohol wipes.
Allow the area to dry completely.
Premask / Handling Tab
Exterior Graphic
3
Separate Liner
Remove liner from Exterior Graphic as shown. To prevent
contamination, limit touching adhesive side of the Exterior Graphic
by using handling tabs.
DESCRIPTION
Exterior Graphics - Side
Exterior Graphic
Liner
Premask
ISSUE
00
Notes to the Installer
1.
Read the entire installation instructions prior to beginning the
installation of the accessory.
2.
Ensure that the vehicle is properly protected in the area that
the accessory is to be installed.
3.
To prevent vehicle damage, never place tools on top of painted
surfaces, seats, dash pad, console or floor carpet / mat.
4.
Always wear appropriate safety gear to include gloves and eye
protection when required.
2
Dry Fit
Align the Exterior Graphic into position using the handling tabs
and character lines on the bottom edge of the rear door.
See Step 7 for more clarity.
Liner
4
Spray Vehicle / Adhesive of Exterior Graphic
Spray the adhesive side of the Exterior Graphic with the soap
and water solution. Then spray the vehicle surface where the
Exterior Graphic will be installed.
DATE
SUBARU OF AMERICA
2/5/24
PAGE
2 / 6
Publicité
