How To Remove And Install The Pullout Drawer - Jenn-Air 12642718 Guide De L'utilisateur

H R
OW TO EMOVE AND
I P
NSTALL THE ULLOUT
D
RAWER
WARNING:
To avoid electrical shock which can
cause severe personal injury or death,
disconnect power to refrigerator
before removing doors. After
replacing doors, connect power.
CAUTION:
To avoid possible injury, product, or
property damage, you will need two
people to perform the following
instructions.
To remove:
1. Pull upper basket out to full extension
and lift out to remove.
2. Remove lower basket by lifting basket
from rail system. (Model design may
vary.)
Or
Press Tab Here
(some models)
3. Pull drawer open to full extension.
4. Remove Phillips screw from each side
of rail system. (Some models)
5. Lift top of door to unhook door
supports from rail system. Lift door
out to remove.
To install:
1. Pull both rails out to full extension.
2. While supporting door, hook door
supports into tabs located on inside
of rail.
7
3. Lower door into final position.
4. Replace and tighten Phillips screws
that were removed from each side of
rail system.
5. With drawer pulled out to full
extension, insert lower basket by
aligning tabs on both sides of lower
basket with notches in rail assembly.
Verify that the basket sides are
hooked securely over the rails.
6. Slide upper basket into freezer. Make
sure that rear of basket hooks behind
rail catch.