Dreame Roboticmower A1 Instruction Originale page 19

• To connect the work area and the charging station
If your charging station is not in the work area, a path should be created to connect it to the work area. Tap
"Path", and remote control A1 to create a path that allows it to return to the charging station.
Note: When creating a path, ensure that one end overlaps with the work area by at least 1 metre ( ≥ 1 m),
and the other end is less than 0.2 metres ( ＜ 0.2 m) in front of the charging station.
Warning: When creating paths to connect the work area and the charging station, do not remotely dock
A1 in the charging station. Otherwise, the LiDAR may be blocked, which can cause the mapping to fail.
6.5 Finish map
Tap "Finish Map" when work areas, paths and no-go zones are completed. A1 should be inside the map
when the map is finished, otherwise you will be prompted to remote control it to move back inside the map.
19 EN