Publicité
Les langues disponibles
Les langues disponibles
5 - Undo the screws
6 - Remove the drip tray (E), drain it and clean it.
7 - Restore the initial conditions after completing
the operation.
To carry out this operation, proceed as fol-
lows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (B) and remove the con-
trol panel (C).
4 - Undo the screw (D) of the pressure con-
nection.
5 - Connect the pressure gauge (E) to the pressure
test point (F).
IT
IT
6 - Turn the gas supply tap back on.
7 - Light the burner and turn the knob to the full
GB
GB
flame setting (see page 8), then check that the
pressure reading complies with the values in
the table (see back of manual).
DE
DE
8 - Switch off the burner, turn off the gas supply tap
and disconnect the pressure gauge.
FR
FR
9 - Restore the initial conditions after completing
the operation.
ES
ES
English
CHECKING GAS PRESSURE
D
A
B
B
C
- 12 -
C
IDM-39617201100.tif
E
IDM-39617201200.tif
E
F
D
Publicité
