LIVARNO home HG00625A Instructions De Montage, D'utilisation Et Consignes De Sécurité page 7

Before installation, make yourself familiar with
all the existing services, e.g. water connection
and stopcocks.
Please read carefully through these operating
instructions before installing and using the product.
Keep all the safety advice and instructions in a
safe place for future reference!
Preparation
Required tools and material
The tools and materials specified are not included.
This information and these values are non-binding
and they are only for guidance. The nature of the ma-
terial is determined by the individual local conditions.
- spanner or adjustable wrench
- sealing tape
- hex key S3
- cleaning brush
Installation
Installing the tap (see Fig. A)
Note: To protect the parts from scratches while
being screwed together cover them with a damp
cloth or use plastic clamps.
Before you start installation turn off the main
water supply to prevent serious leakage of water.
Install the tap at the wall connection as shown
in Figure A.
Wrap the S-connecter
Screw the nuts with a spanner or an adjust-
4c
able wrench.
Connecting the accessories (shower head
and shower hose)*:
Note: So that the parts do not get scratched while
being screwed together, protect them with a damp
cloth or use plastic clamps.
with sealing tape.
1
Screw an ordinary shower hose* firmly on to
the thread .
4b
Attach an ordinary shower head* to the
shower hose*.
Observe the installation instructions for the
accessories.
* (not included)
Flushing the tap
The tap must be flushed through before first use
to remove any dirt. To do this, follow these steps
(see Fig. B):
Screw the mixer nozzle
Before using the tap for the first time, open the
main water supply and allow the water to run for
two minutes so that any residues are dissolved
away.
Then screw the mixer nozzle on again.
Operation
Bringing into use
Note: If the tap has not been used for a long period
flush the pipes through thoroughly in order to avoid
stagnation and build-up of residues in the drinking
water supply.
Adjusting the flow
Turn the water flow switch
water flow.
Increase:
Turn the water flow switch upward.
Reduce:
Turn the water flow switch downward.
Adjusting the water
temperature
Turn the temperature control switch
adjust the water temperature.
off.
5
to adjust the
6
to
7
GB/IE/NI 7