Publicité
Les langues disponibles
Les langues disponibles
Maintenance and care
7.3
Trouble shooting
Dysfunction
Palletised parcel tips over
Package does not fit under pallet fork
Forks can no longer be adjusted
Pallet fork can no longer be adjusted
in height
Hydraulically actuated centre of
gravity compensation can no longer
be adjusted
The pallet fork hangs askew
7.4
Repairs
Only persons with the appropriate knowledge and ability are allowed to repair the device.
Before the device is used again, it has to be checked by a qualified person or an expert.
7.5
Safety procedures
•
It is the contractor's responsibility to ensure that the device is checked by an expert in periods of
max. 1 year and all recognized errors are removed (→ DGUV norm 100-500).
•
The corresponding legal regulations and the regulations of the declaration of conformity must be
observed!
•
The expert inspection can also be done by the manufacturer Probst GmbH.
Contact us at:
•
We recommend affixing the inspection sticker "„Sachkundigenprüfung / Expert inspection" in a
clearly visible place (order no.: 2904.0056+Tüv sticker with year number) after the inspection has
been done.
56000010 / 56000011 / 56000025 / 56000024
Cause
Fork spacing is not correct
Position of the suspension to the
package is not correct
Height-adjustable handle is set too
low
Pallet fork bar is bent
Handle of the pallet fork is bent
Treads warped
Hydraulic cylinder piston rod bent
Hydraulic pressure of the lorry loading
crane too low
The pallet fork is loaded on one side
The pallet fork cannot swing freely
service@probst-handling.de
Set the fork spacing correctly
Correctly adjust the suspension via
the hydraulic centre of gravity
compensation
Adjust the height-adjustable handle
Replacing the lower part of the pallet
fork
Replace running surfaces
Replace piston rod
Check connections, screw
connections, gasket sets, return line
filter
Distribute load symmetrically
Check gimbal suspension or remove
obstruction
20 / 21
Remedy
GB
Publicité
