Publicité
Les langues disponibles
Les langues disponibles
CLEANING INLET AND OUTLET VALVES
1. Remove the Non-Needle Guard Attachment by pulling forward on the Non-Needle
Guard Attachment.
2. Slide the Dose Chamber forward, removing it from the Handset.
3. Slide Inlet and/or Outer Valve Assembly out of the valve chamber.
4. Rinse Valve Assembly under water. Ensure no debris is present.
5. Place Inlet and/or Outlet Valve Assembly back into valve chamber. Ensure the
Valve Assembly is replaced flush with Dose Chamber, and the Connection Lug is
protruding through the underside of the Dose Chamber.
6. Slide the Dose Chamber onto the Handset and replace the Non-Needle
Guard Attachment.
STORAGE
Never store with needle attached. Injector must be cleaned and lubricated prior to
storage. Store in a clean, dry place out of reach of children. Protect from direct sunlight.
No responsibility or liability will be accepted by the manufacturer for use of this
veterinary injector other than in accordance with the enclosed operating instructions.
IMPORTANT ALWAYS READ THE LABEL:
Check the label on the pharmaceutical manufacturer's container for dose rates,
precautions, and safety information prior to use.
VETERINARY USE ONLY
SHORT-NECKED BOTTLES (with Bottle Mount):
1. Most bottles up to 100mL will fit tightly into the shroud.
2. Short-necked vaccine bottles may not fit tightly into the shroud or "click in" tightly
due to bottle interference with the shroud.
3. In this case, the bottle can still be used, but must be monitored closely during use.
Or the vaccine can be mixed according to the manufacturer's instructions and
then placed back in the diluent bottle. The diluent bottles have longer necks and
will "click" down into the shroud.
In the illustration below, the bottle on the left may not click all the way down
due to the short neck and wide shoulders. The bottle on the right will fit due to
the longer neck and narrow shoulders.
Short-necked
bottle
Left
Long-necked
bottle
Right
Publicité
