Publicité
Les langues disponibles
Les langues disponibles
EQ effects
Press the EQ button on the remote repeatedly to cycle through a set of equaliser presets to adjust
the sound. Choose from CLASSIC, POP, ROCK, JAZZ, MOVIE and Off.
Mute function
Press the button
at any time to mute the sound output.
Press again to unmute.
Tone controls
To adjust the bass, use the BAS+ or BAS- buttons on the remote control.
To adjust the treble, use the TRE+ or TRE- buttons on the remote control.
Standby mode
Press the STANDBY button on the unit or the remote to put the system into standby mode. To
resume normal operation, press this button again.
NOTE: This unit is designed to enter STANDBY mode automatically, after about 15 minutes
(approximately) of inactivity. Press STANDBY button to wake the unit.
NOTE: When you power on the unit from standby, it will resume in the mode that was last used.
Operations
■ FM radio operation
1. Press the source button
mode. (FM frequency 87.50 -108.00MHz)
2. Press the
buttons on remote control to decrease or increase the frequency in 100KHz
increments.
3. Press and hold the
quickly. The scan will stop once it has found a station.
4. Press and hold the
stations found automatically.
5. SAVE a station: You can store up to 50 FM stations in memory. Press the FREQ button and
then, using the number buttons enter the frequency that you want to store.
Press the SAVE button, it will show " P01" on the display. Press the
station preset number you want to save the frequency under. Press the SAVE button again to
confirm.
6. Recall the preset stations: Press the
on the unit, or MODE button on the remote control to enter the FM
buttons on remote control to scan through the frequency range
button to scan through the frequency range quickly; it will store any
button to recall your stored stations.
button to select the
Publicité
