Sharp XL-B530 Mode D'emploi page 19

System connection
■ Preparation for use
1. Place a speaker on either side of the main unit, preferably at the same height and with at least
150mm space between each speaker to the main unit. Connect the speaker plugs to the rear of
the unit. Take care to match the speaker placed to the LEFT to the LEFT output on the rear of
the unit. Repeat for the RIGHT speaker.
2. Please ensure that the voltage marked on the rating label, located on the rear panel, is the same
as the voltage in your area. Insert the end of the power lead in to the AC IN socket on the back
of the unit. Plug the other end of the cable in to the wall socket.
3. Press the STANDBY button on the main unit to turn it ON. Extend the ANTENNA to get the
best reception. Press the source button on the unit, or FM button on the remote control to enter
the FM mode. To use the radio in FM mode, follow the instructions in the FM RADIO
OPERATION chapter of this manual.
4. Press the STANDBY button on the main unit to turn it ON. Extend the ANTENNA to get the
best reception. Press the source button on the unit, or AM button on the remote control to enter
the AM mode. To use the radio in AM mode, follow the instructions in the AM RADIO
OPERATION chapter of this manual.
5. Press the source button
the Aux In (Audio) mode. Connect your audio device to the AUX IN socket via AUX-cable
RCA-RCA Stereo Type. Control playback via your connected audio device.
6. Press the source button
the CD mode. Press the
button again to close. The CD will begin playing from the first track.
7. Press the source button
USB mode. Plug the USB device to USB port on the front panel of the unit, and it will read the
USB and play automatically.
8. Press the source button
the Bluetooth mode. Activate the Bluetooth enabled device and select the "SHARP XL-B530".
Select the song you want and press to play.
■ Basic functions
Switching modes
To switch between the modes:FM, AM, AUX, CD, USB, and Bluetooth, press SOURCE button
on the unit or the MODE button on the remote control.
Volume control
1. Increase: Rotate the VOLUME control on the main unit clockwise or press the VOL+ button on
the remote.
2. Decrease: Rotate the VOLUME control on the main unit anticlockwise or press the VOL-
button on the remote.
on the unit, or MODE button on the remote control button to enter
on the unit, or MODE button on the remote control button to enter
button to open the disc drawer and insert a disc. Press the
on the unit, or MODE button on the remote control to enter the
on the unit, or MODE button on the remote control button to enter