Publicité
Les langues disponibles
Les langues disponibles
INSTALL RANGE HOOD INTERNAL BLOWER
Parts supplied
Remove parts from packages. Check that all parts are
included.
Blower square notches
4.2 x 8 mm screws
6- 9 wire blower connector
Blower spring clip
Fixation Motor Bracket
Torx 20 adapter
6.4 x 11 mm washers
6 x 16 mm screws
Install the internal Blower
1
Remove grease filters from range hood. See the
"Maintenance" section in the hood's Use and Care Guide.
2
Install the motor support bracket using three 4.2 x 8 mm
screws. Screw bracket to the inside top, toward the left
side of the hood's upper wall.
3
Install motor spring clip using two 4.2 x 8 mm screws.
Screw spring clip to the inside top of the hood.
Slide the mounting tab of the spring clip through the slot
in the panel and secure with the screws.
5
C
5
1
4
1
1
5
A. Motor Support Bracket
B. Motor Spring Clip
5
4
Install the 5 - 6 mm clip nuts to the outside top of the hood
at the location indicated in the lower image.
5
Locate the range hood blower motor assembly inside the
range hood canopy with the wiring connection to the front or
top for the dual motor system.
C
A
C. Installation screws
A
A. Wiring connection
B
3
Publicité
