Beta 8135 Mode D'emploi page 14

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
Insert the plate inside the seat on the clamp body until it touches the bottom of the seat (Fig. 4).
Release the lever until the cam touches the surface of the sheet metal (Fig. 5); then tighten it back into the original position (fig.6).
The manual effort required to tighten the mechanism depends on the thickness of the sheet metal and increases as it increases.
You can then proceed with handling and/or lifting the load.
The pincer joint allows a sheet to be rotated and/or tilted without coming off the ground and without going over the vertical
(fig. 7); again, the load must be gripped correctly and securely (fig. 8).
14
8135.indd 14 8135.indd 14
Fig. 5
Fig. 4
Fig. 6
Fig. 7
Fig. 8
EN I
27/05/24 09:46 27/05/24 09:46