4-position switch settings
Both heating elements switched
off
Upper heat
Lower heat
Upper heat and lower heat
The heating elements will only be switched
on after the timer is activated.
Timer
∙ By means of the timer, the cooking time
can be selected up to a maximum of 60
minutes.
∙ To programme a time, turn the timer
knob clockwise to the desired value.
∙ To set a time of less than 10 minutes,
turn the timer to a somewhat higher
setting first and then slowly turn it back
to the desired time setting. After the
pre-programmed time has elapsed, an
acoustic signal indicates that the heating
elements are switched off.
Indicator lamp
The indicator lamp lights up when the
appliance is switched on. It goes out once
the pre-programmed time has elapsed, or if
the switch is turned back to position
Start up
∙ Clean the appliance (see Cleaning and
care) and remove any packing materials
completely (including stickers if any).
∙ Before using the appliance for the first
time, let it heat up for 10 minutes with
the door closed, using both the upper
and lower heating elements. When the
appliance is switched on for the first
time, a slight smell may be emitted. This
is normal and will only last for a very
short time. For that reason, adequate
ventilation should be ensured by
opening windows or balcony doors.
Operation
∙ Caution: Before using the appliance,
make sure that the crumb tray is fitted in
its proper position underneath the lower
heating element.
∙ Pre-heat the oven compartment for
several minutes with the door closed,
using both heating elements. Set the
temperature control knob to the required
level and use the timer control knob to
select the desired pre-heating time.
∙ Place the food to be cooked on the
baking rack. When cooking food
containing fat or moisture, use the
baking tray to stop any dripping into the
interior of the appliance.
Close the door, set the temperature
control knob to the required level and
use the timer knob to select the desired
cooking time.
∙ For overhead baking or grilling, either
the upper or the upper and lower
.
elements may be selected.
∙ The switch settings (upper heat/lower
heat) may be changed during the
cooking process.
∙ After the pre-programmed cooking time
has elapsed, the timer will automatically
switch off the heating elements.
∙ To switch off the appliance earlier, set
the timer to position
∙ Always use the door handle to open
the hot door after use. When removing
.
13