Publicité
Les langues disponibles
Les langues disponibles
STOP
A
4
B
8
7
C
10
D
18
PUTTING INTO OPERATION
CAUTION:
Before doing any work on the guide bar or chain, always
switch off the engine and pull the plug cap off the spark
plug (see "Replacing the spark plug"). Always wear pro-
tective gloves!
CAUTION:
Do not start the saw until it has been completely assem-
bled and inspected!
Mounting the guide bar and saw chain
Use the universal wrench delivered with the chain saw for the
following work.
Put the chain saw on a stable surface and carry out the
following steps for mounting the guide bar and chain:
1
Disengage the chain brake by pulling the hand guard (1) in the
2
direction of the arrow.
Unscrew retaining nut (2).
Spread the sprocket guard (3) slightly, push it out of the
mounting (4) and remove it.
3
Remove the transport cover (5).
Turn the chain tensioning screw (6) to the left (counter-clock-
wise) until the lug (7) is below the guide pin (8).
5
6
Position the guide bar (9). Make sure that the pin (10) of the
chain tightener is in the hole on the guide bar.
9
Publicité
