Technical data
Single-cylinder two-stroke
Piston displacement
Cylinder bore
Piston stroke
Max. power at speed
Max. torque at speed
Idling speed / max. engine speed with bar and chain
Sound Pressure Level at the operator's ear
at full load according to ANSI B 175.1
Sound Pressure Level at the bystander's position
(50ft/15 m distance) according to ANSI B 175.1
Ignition system
Electronic, without breaker
Spark plug
or Spark plug
Electrode gap
Fuel system
Carburetor
(all position diaphragm carburetor
with integral fuel pump)
Fuel tank capacity
Fuel mixture
Weight
without cutting attachment
Cutting attachment
Guide bar
Cutting length
Safety saw chain (pitch)
Drive link gauge
Chain sprocket
Chain lubrication
Oil tank capacity
Approved bar and chain combinations
"Low-kickback saw chain is a chain which has met the
kickback performance requirements of ANSI B 175.1-
1991 (American National Standard for Power Tools-
Gasoline-Powered Chain Saws-Safety Requirements)
when tested on the representative sample of chain
saws below 3.8. C.l.D. specifed in ANSI B 175.1-
1991". The approved bar and chain combinations are
low kickback chains according to ANSI B 175.1-1991
and also meet the kickback requirements of CSA
Z62.3-96 for chain saws below 80 cm
The chain saw DCS 330 TH has been approved
with following guide bar and chain combinations:
Drive link gauge .050"
MAKITA:
Guide bar 3/8"
length
Part no.
14" (35 cm)
1682473
OREGON:
Guide bar 3/8"
length
Part no.
14" (35 cm)
140SDEA041
"There may be other replacement bar and chain combi-
nations available that also reduces the risk of injury
from kickback".
3
.
Saw chain 3/8"
Part no.
91VG-52E
Saw chain 3/8"
Part no.
91VG-52E
DCS 330 TH
1.96 cu. in (32.3 cm
1.45" (37 mm)
1.18" (30 mm)
1.0 / 7,000 kW/rpm
1.45 / 5,800 Nm/rpm
2,800 rpm / 11,000 rpm
100 db(A)
76 db(A)
CHAMPION RCJ 8
NGK BMR 6A
.020" (0.5 mm)
WALBRO WT with limiter caps
8.8 oz. (0.25 l)
see chapter "Fuel"
7 lbs. 15 oz. (3.6 kg)
sprocket nose bar
14" (35 cm)
3/8
.050
6 teeth
fully automatic oil pump (variable-flow)
5.6 oz. (0.16 l)
WARNING
Do not use other replacement bars and chains
unless they have been designated as meeting the
ANSI B 175.1-1991 (for USA) and CSA Z62.3-96
(for Canada) kickback performance requirements
on that specific powerhead, or has been desig-
nated as "low kickback" saw chain in accordance
with the ANSI B 175.1-1991 (for USA) and CSA
Z62.3-96 (for Canada) standard.
3
)
17