Child Safeguard/Operating Lock; Activating Heating Pause (Battery Saving); Setting The Frost Protection Mode; Window Open" Function - eQ-3 L Mode D'emploi

le temperature appear in the display.
• Change the temperature with the selector dial and con-
firm with the OK key.
• The Moon symbol ( ) and the reduced temperature ap-
pear in the display.
• Change the temperature with the selector dial and con-
firm with the OK key.
The temperature can also be changed in Auto Mode at any
time via the key. This is then retained until the next swit-
ching time point of the program.
15. Child safeguard/opering lock
The operation of the device can be blocked.
• To activate/deactivate the operating lock, press the Mode/
Menu and keys at the same time.
• After it has been successfully activated, „LOC" appears
in the display.
• To deactivate the operating lock, press both keys again.

16. Activating heating pause (battery saving)

The temperature can also be changed in Auto Mode at any
time via the key. This is then retained until the next swit-
ching time point of the program.
To activate the heating pause proceed as follows:
• Turn the selector dial in manual Mode (Manu) to the right
until „ON" appears in the display.
• To end it, exit the manual Mode (Manu) or turn the se-
lector dial to the left.
•
48 48

17. Setting the frost protection Mode

If a room is not to be heated, the valve can be closed.
• Turn the selector dial in manual Mode (Manu) to the left
until „OFF" appears in the display.
•
The valve is only opened if there is danger of frost. The protec-
tion against calcification continues however to be carried out.
• To end it, exit the manual Mode (Manu) or turn the se-
lector dial to the left.
18. „Window open" function
With a rapidly reducing temperature, the actuator auto-
matically detects that a room is being ventilated. In order
to save heating costs, the temperature is then regulated
down for a certain period of time (15 minutes, set at the
factory). During this period the „Window open" symbol
is shown in the display.
To activate this function proceed as follows:
• Press the Menu key longer than 3 seconds.
• Select the „AER" menu item with the selector dial and
confirm with the OK key
• The temperature and time can be set with the selector
dial. The function can be deactivated by selecting „0"
for the time.
49 49