Domo DO920DV Mode D'emploi page 38

Les langues disponibles

Wipe the door seal with clear water only and then wipe dry thoroughly.

After cleaning reconnect and adjust the temperature control knob as desired.

Put the food back into the appliance.

DEFROSTING

A layer of frost in the freezer will impair refrigeration of the frozen food and increases power

consumption. Remove the layer of frost regularly. Do not scrape off frost or ice with a knife or

pointed object. Doing this may damage the refrigerant tubes.

Remove the frozen food and place temporarily in a cool location.

Disconnect the appliance from the mains socket.

To accelerate the defrosting process, place a pan of hot water on a stand in the freezer.

Wipe up condensation with a cloth or sponge.

Wipe dry the freezer compartment.

Plug in the appliance and adjust the temperature control knob as desired.

Put the frozen food back in the freezer.

VACATION TIME

For short vacation periods, leave the control knobs at their usual settings. During longer

absences;

· Remove all foods.

· Disconnect from electrical outlet.

· Clean the refrigerator thoroughly, including defrost pan.

· Leave door open to avoid possible formations of condensate, mold or odors.

POWER FAILURE

· Most power failures are corrected within an hour or two and will not affect your refrigerator

temperatures. However, you should minimize the number of door openings while the

power is off. During power failures of longer duration, take steps to protect your food by

blacking dry ice on top of packages.

· Frozen food should not be affected if the power failure lasts for less than 15 hours.

· Do not refreeze frozen foods that have thawed completely. The food may be dangerous to

eat.

DOOR CONVERSION

If you need to hinge your door on the opposite side it is recommended that you call your local

authorised service agent to make this conversion or ask a technician. Before you reverse the

door, you should ensure the appliance is unplugged and empty. It is recommended to use a

crosshead screwdriver and a spanner (both not supplied).

DO920DV