Domo DO920DV Mode D'emploi page 40

8. Use a spanner to tighten it if necessary.
9. Put the top cover back and fix it in place with the screws.
10. With the door closed, check that the door is aligned horizontally and vertically and that
the seals are closed on all sides before finally tightening the bottom hinge. Readjust the
levelling feet as required.
MOVING YOUR APPLIANCE
If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This
will allow the refrigeration system pressures to equalise before restarting.
· Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove
all mobile parts (shelves, accessories, etc.) or fix them into the fridge to avoid any shock.
· Relocate and install. If the appliance has been left on its side for any length of time, leave it
standing upright for at least 10 minutes before turning on.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally
friendly and natural gas, it is explosive. Therefore you should be careful during shipment and
installation to prevent your appliance's cooler elements from being damaged. In the event of
a leak caused by damage to the cooler elements, move your fridge from open flame or heat
sources and ventilate the room where the appliance is located for a few minutes.
TROUBLE SHOOTING
Frequently, a problem is minor and a service call may not be necessary, use this trouble
shooting guide for a possible solution.
Does not work.
· Check connection of power cord to power source.
· Plug in unit
· Use proper voltage.
The appliance is too cold.
· The temperature has been set too cold. Raise the temperature slightly.
40
DO920DV