Publicité
Prendre la plaque de fixation du coté droit (article 12 – PLAQUE 0183) et placer les 2 boulons M6 les plus
courts (article 11 – 45mm) dans les 2 petits trous de la plaque.
Pour monter la protection crash du coté droit, glisser la rondelle 12mm restante (article 7) sur le boulon
M12 x 190mm (article 10) façon à ce que la rondelle ce place contre la tête du boulon.
Glisser une rondelle de blocage (article 6) sur le boulon pour qu'elle se place contre la rondelle tout juste
insérée.
Glisser le boulon muni de ses rondelles dans la protection crash (article 5) de façon à ce que la tête du
boulon et les rondelles se placent dans le contre alésage.
Monter cet ensemble sur la plaque de fixation et insérer le boulon dans le trou restant de la plaque, en
veillant à ce que l'entretoise longue restante (article 13 – S0970 – 91.50mm de long) se place entre la
plaque et le cadre, avant de l'insérer dans le support moteur avant et de replacer l'écrou de blocage
d'origine sur le filetage à l'arrière, voir photos 9 & 10.
Serrer ce boulon de même que les 2 boulons M6 insérés dans le carter moteur, selon les couples de
serrage recommandés, voir page 3.
Serrer le boulon de protection crash jusqu'à ce que vous sentiez la compression s'accentuer
dans la protection, en utilisant une clé de 19mm. LA PROTECTION DOIT ETRE POSITIONNEE
COMME EN "C" AVEC LE COTE ARRONDI LE PLUS GROS EN DIRECTION DE L'AVANT DE LA
MOTO. Tourner un peu plus afin d'accentuer légèrement la compression. Faire un quart de
tour. Pas plus de 40 Nm de couple - Ne pas trop serrer, au risque d'abîmer les composants
Placer le sticker R&G dans le creux de capuchon de la protection.
Insérer les capuchons des protections dans les protections
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do
not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no
representation or warranty (other than as to title) has been given or will apply to the Products other than those in R&G's order or confirmation
and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits the
Products or undertakes other services it shall exercise reasonable skill and care and rectify any fault free of charge unless the workmanship has
been disturbed. The Buyer is responsible for ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return
of any defective Products R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products
have been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good engineering
practice or if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting its liability for causing death
and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the
Buyer for the Products or the fitting or service concerned. These terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased
direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the
opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price
at time of purchase). The customer must pay any and all carriage charges. No returns of discontinued products, unless within 14 days of purchase.
This policy does not affect your statutory rights and does not refer to faulty goods.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 13/07/2016 (AR)
Notice disponible au téléchargement sur
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
.
www.rg-racing.com
R&G Racing
www.rg-racing.com
Email:
CP0407
info@rg-racing.com
.
Publicité
