Replacing The Wheels - Skil PM4910-00 Guide D'utilisation

Replacing the Wheels

WARNING
1. Turn the mower on its side with the upper surface against a wall.
2. Use a flat blade screwdriver to pry the dust cover away from the wheel.
3. Use an adjustable or 1/2 inch (13mm) wrench to turn the bolt counterclockwise to loosen
it.
For the front wheel (Fig . 26), and the rear wheel of the non-self-propel lawn mower
(Fig . 27):
4. Remove the bolt, the worn wheel from the wheel axle.
5. Mount the new wheel on the wheel axle. Note that the round recess must face outward.
6. Lock the wheel with the bolt by tightening the bolt clockwise.
7. Mount the dust cover onto the wheel and press it in place.
Fig. 26
Bolt
Front
Wheel
For the rear wheel of the self-propel lawn
mower (Fig . 28), remove the drive gear from
the worn wheel and assemble it to the new
wheel with the 3 screws.
28
Always remove the battery pack when servicing or transporting the mower.
Dust Cover
Wheel Axle
Fig. 27
Bolt
Fig. 28
Bolt
Screws
Dust Cover
Rear Wheel
Wheel Axle
Dust Cover
Rear Wheel
Drive Gear
Wheel Axle