Operating Instructions - Skil PM4910-00 Guide D'utilisation

OPERATING INSTRUCTIONS

WARNING
fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing products, etc. can cause a short
circuit.
WARNING
could result in serious personal injury.
WARNING
eyes and other possible serious injuries.
WARNING
serious injury .
Before each use, inspect the entire product for damaged, missing, or loose parts, such as
screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced.
Adjust the Cutting Height (Fig . 11)
WARNING
lawn mower without first stopping the
motor, removing the battery pack, and
waiting for the blade to stop rotating .
WARNING
its height .
The mower can be set to any of 7 cutting
heights between 1-1/2'' and 4''. Choose the
proper cutting height according to the type and
condition of the grass.
1. Use one hand to hold the nearby handle
tube for stability and use the other hand
to move the cutting-height adjustment lever outwards from the slots in the cutting-height
indication plate.
2. Move the cutting-height adjustment lever toward the back of the mower for a higher cutting
height; move it toward the front of the mower for a lower cutting height.
3. Once arriving at the desired cutting-height position, engage the cutting-height adjustment
lever back into the slot.
18
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack, or charger in
If any parts are damaged or missing, do not operate this product until
the parts are replaced . Use of this product with damaged or missing parts
Always wear eye protection with side shields marked to comply with
ANSI Z87 .1 . Failure to do so could result in objects being thrown into your
Do not allow familiarity with this product to make you careless .
Remember that a careless fraction of a second is sufficient to inflict
Do not at any time make
any adjustment to the
Keep your feet away from
the deck when adjusting
Fig. 11
Cutting-Height
Adjustment Lever