Franklin Electric UP16M Manuel D'installation page 3

SYMPTOM
Motor does not run
Motor hums but flow
is reduced or none at all
SAFETY TIPS (ELECTRICAL)
1) Never make adjustments with the power connected.
Always disconnect your pump from the electrical outlet
before beginning any service procedures.
2) Do not stand on wet fl oor when servicing.
3) Do not put your fi nger into the fuse socket - it could be
fatal.
4) Never remove the round pin from your plug; this is the
ground and is there for your safety.
TROUBLESHOOTING
CAUSE
Blown fuse
Tripped circuit
Disconnected plug
Corroded plug
Tripped overload
Defective switch
Defective motor
Float-improper position
Impeller jammed
Plugged check valve
Partially blocked inlet
Line leak
Worn impeller
Defective motor
Replace fuse
Reset
Reinstall
Clean prongs
Allow pump to cool, investigate cause (jammed
impeller)
Replace switch
Replace pump/repair
Check for freedom of movement
Remove bottom plate and clean.
Remove valve, clean or replace
Clean inlet
Repair
Replace pump/repair
Replace pump/repair
3
REMEDY