Grundig GEBM19300BMP Manuel D'utilisation page 6

• Plug the product into an outlet
that meets the voltage and fre-
quency values specified on the
type label.
• If your product does not have a
power cable, only use the
power cable described in the
"Technical specifications" sec-
tion.
• Do not jam the power cable un-
der and behind the product. Do
not put a heavy object on the
power cable. The power cable
should not be bent, crushed,
and come into contact with
any heat source.
• The rear surface of the oven
gets hot when it is in use.
Power cords must not touch
the back surface, connections
may be damaged.
• Do not jam the electric cables
into the oven door and do not
pass them over hot surfaces.
Otherwise, cable insulation
may melt and cause fire as a
result of short circuit.
• Use original cable only. Do not
use cut or damaged cables or
intermediate cables.
• If the power cable is damaged,
it must be replaced by the
manufacturer, an authorized
service or a person to be spe-
cified by the importer company
in order to prevent possible
dangers.
• CAUTION: Before replacing
the oven lamp, be sure to dis-
connect the product from the
mains supply to avoid the risk
of electric shock. Unplug the
product or turn off the fuse
from the fuse box.
If your product has a power
cable and plug:
• Do not plug the product into an
outlet that is loose, has come
out of its socket, is broken,
dirty, oily, with risk of water
contact (for example, water
that may leak from the
counter).
• Never touch the plug with wet
hands! Never unplug by pulling
on the cable, always pull out by
holding the plug.
• Make sure that the product
plug is securely plugged into
the outlet to avoid arcing.
1.4 Transportation
Safety
• Disconnect the product from
the mains before transporting
the product.
• The product is heavy, carry the
product with at least two
people.
• Do not use the door and / or
handle to transport or move
the product.
EN / 6
EN
FR