Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
·
Assembly types 1170 and 1400:
Attention! The adjustment lever (B) must not be locked. It
de
·
will be unlocked by moving the locking switch (E) upward
(fig. 2ⓐ).
·
Place the top blade on the drive pin.
en
·
Before assembly, the bottom blade and the top blade
should be oiled (Fig. 5).
·
Position bottom blade and replace both screws.
fr
·
When assembling, the bottom blade and the top blade
should be aligned as follows (Fig. 6):
The top blade must be parallel with the bottom blade with a
gap of 0.5 – 1.0 mm before tightening the screws.
it
This gap should also be maintained when screwing the bot-
tom blade back into place after thorough cleaning; failure to
do so could result in injury.
es
·
Tighten both screws (Fig. 7).
·
Assembly type 1411:
·
Position the top blade on the cam (Fig. 7).
·
Before assembly, the bottom blade and the top blade
pt
should be oiled (Fig. 5).
For easier assembly, secure the spring ends. To do this,
·
press spring ends down with a pair of tweezers and secure
nl
them in the recess of the housing (Fig. 8).
·
Position the top blade with the cam on the housing.
·
Position bottom blade and replace both screws.
·
When assembling, the bottom blade and the top blade
sv
should be aligned as follows (Fig. 6):
The top blade must be parallel with the bottom blade with a
gap of 0.1 – 0.5 mm before tightening the screws.
da
This gap should also be maintained when screwing the bot-
tom blade back into place after thorough cleaning; failure to
do so could result in injury.
·
Tighten both screws (Fig. 7).
fi
·
Undo the fixing of the spring. With a screwdriver, press both
spring ends inwards (Fig. 9).
tr
Disposal in EU countries
Do not dispose of the appliance with domestic refuse. As
part of the EU Directive governing the disposal of electri-
pl
cal and electronic equipment, the appliance is accepted
free of charge by local waste collection points or recycling
centres. Correct disposal will ensure environmental pro-
tection and prevent any potentially harmful impacts on
cs
people and the environment.
Disposal in non-EU countries
sk
Please dispose of the appliance at the end of its service life in an
environmentally friendly manner.
hu
hi
ru
uk
el
ar
fa
8
Guarantee
1. The rights based on this guarantee shall be in addition to the stat-
utory and/or contractual claims for defects in material which the
customer is entitled to assert against their respective seller. These
rights shall not be limited by the guarantee.
2. For small electric appliances, WAHL GmbH shall grant a guaran-
tee that the appliance is free of defects.
Parts that are subject to wear and tear such as shaver foils, drive
components, blade sets, attachment brushes, batteries or battery
cells are not included in this guarantee.
The guarantee is excluded if
·
the appliance has been misused or treated carelessly,
·
the appliance has been damaged due to excessive stress,
incorrect use or external influence,
·
the defect has been caused by failure to observe the oper-
ating instructions,
·
a repair or a repair attempt has been carried out by person-
nel other than that of a WAHL GmbH factory or of an autho-
rised point of sale.
3. The guarantee period shall be in accordance with the duration of
the statutory limitation period for liability for material defects stipu-
lated by the national law of the state in which the appliance has
been acquired; however, it shall not be longer than 3 years.
The period shall start upon handover of the appliance by the seller
to the purchaser.
Place of purchase and time of handover shall be proven by pre-
sentation of a proof of purchase such as receipt, invoice, delivery
note or the like.
4. Defects arising within the guarantee period and notified to us
in text form within three weeks after their appearance shall be
removed by WAHL GmbH free of charge in line with this guar-
antee. Repairs shall be performed in a WAHL GmbH plant or in
a point of sale authorized by WAHL GmbH. WAHL GmbH shall
be entitled to remove the defect also by delivery of an appliance
identical in construction. There shall be no further claims of the
customer based on this guarantee, especially for reimbursement
of expenses, reduction of the purchase price, damages or the right
of rescission. Statutory or other contractual claims for defects in
material shall remain unaffected.
There shall not be any extension of the guarantee period due to
activated guarantee.
5. The parts exchanged in line with repairs under the guarantee and
the appliance retained in case of replacement shall become prop-
erty of WAHL GmbH.
6. If our customer service is used without justification, WAHL GmbH
shall be entitled to charge the customer for the costs accrued.
7. In case any defects occur, please contact your dealer or the Ser-
vice Centre in your country.
Publicité
