Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT:
If wheels were removed, cover the floor when
moving the dishwasher to avoid damage to the floor. Slowly
move dishwasher completely into cabinet opening. Do not kink or
pinch water line, drain hose, power supply cord or direct wire
between dishwasher and cabinet. Remove cardboard from under
dishwasher.
NOTE:
It is all right if dishwasher fits tightly into cabinet opening.
Do not remove insulation blanket ~ the blanket reduces the
sound level.
NOTE:
If using power cord, make sure to route end through hole
in cutout before sliding into cabinet opening.
Align front of dishwasher
with front of cabinet doors
SAScg
SS
Align front of dishwasher door panel with front of cabinet doors.
You may need to adjust alignment to be even with your
cabinets.
1g) Check for plumb and
adjust legs if needed
P T
SRS
SS
Check that leveling legs are firmly against the floor.
Close and latch the door, and place level against the
front panel. Check that dishwasher is centered from front to back
in the opening. If needed, adjust leveling leg until dishwasher is
plumb. Repeat for other side of dishwasher.
Helpful Tip: Push up on front of dishwasher to raise dishwasher
off the ground to adjust front legs. With some installations, it
may be easier to adjust the front leg using the "%6" hex head
socket or adjustable wrench.
Optional method
Preferred method
10} Check level side to side and
adjust legs if needed
<li
eG
Cea
Re
SNAY
Wh
(
Place level against top front opening of tub. Check
that dishwasher is level from side to side. If dishwasher is not
level, adjust front legs up or down
until dishwasher is level.
Be sure rubber washer is properly seated in fitting. Slide the 44"
fitting up to the valve and hand tighten to avoid unintentional
cross-threading. Hand tighten until the coupling is tight. Using
pliers, check the tightness of the coupling. An additional 4 to %
turn may be required to seal the rubber gasket.
NOTE:
Do not overtighten. Damage to the coupling can result.
Check for leaks
Place paper towel under 90° elbow fitting. Turn on water
supply and check for leaks. If leak occurs, repeat previous step.
If needed, see website for animated representation
of this step. Visit www.whirlpool.com/watersupply
under
FAO tab.
NOTE:
Do not use Teflon™ tape with compression fittings.
T° TEFLON
is a registered trademark of E.1. Du Pont De Nemours and Company.
15
Publicité
