Publicité
Les langues disponibles
Les langues disponibles
Wiring configuration
Power supply.wire:
Terminal box wire:
white =< white
black ~«—-—»-. black
ground wire «<———»-. ground connector
lf needed, see website for animated representation of this step.
Visit www.whirlpool.com under FAO tab.
Power Cord—Secure cord
on conduit connector
Power Cord—Reinstall
terminal box cover
left side of cover. Make sure wires are tucked inside box. Close
cover ensuring wires are not pinched. Use 4" nut driver and
previously removed screw to secure cover.
NOTE: Do not plug into outlet until instructed.
12
Determine Cabinet Opening
1 | Measure cabinet opening
Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed (you will
need to measure the lowest point on the underside of the
countertop and the highest point on the floor). Refer to
"Dishwasher Height Adjustment Chart" for wheel position and
the number of turns needed.
Dishwasher Height Adjustment Chart
Cabinet
Wheel
Number-.of turns
opening height
position
on-front leg
337" (86.0 cm)
Removed
All the way-up
34" (86.4 cm)
1
10
3414" (87.0 cm)
2
5
34V2" (87.6 cm)
3
0
gy
NOTE: If the minimum
cabinet opening height Is less than 34"
(86.4 cm), the rear wheels can be removed for additional
clearance. This will allow the dishwasher to fit into a 3374"
(86 cm) high cabinet opening, but the dishwasher will be more
difficult to move. (Measurements are approximate. Wheels and
legs are preset at the factory for 34%" [87.6" cm].)
2 | Adjust wheels and legs
CE
x
* SS
is
Turn both leveler legs to the same height. Put wheels in the
required position determined from "Dishwasher Height
Adjustment Chart." (To change wheel position, use a flat-blade
screwdriver to pop out the wheel, then snap into the new
position.)
Publicité
