Publicité
Les langues disponibles
Les langues disponibles
Built-up Floors — Add
shims as needed
Built-up floors (Kitchen floor height is higher than cabinet
opening.) Example: Kitchen floor tile does not extend into
cabinet opening. Add shims as needed in the area shown to
bring the dishwasher up to 34" (86.4 cm) below the countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
Choose Attachment Option
AWARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Using two or more people, stand the dishwasher up.
IMPORTANT: The dishwasher must be secured to the cabinet.
There are two brackets, found in the parts bag, attach the brackets
to the top of the dishwasher if the countertop if it is wood,
laminate or another similar surface.
If your countertop is marble,
granite or another hard surface, install using Option 2.
Option
1, Countertop attachment
1.
Remove the brackets from the package and place in the open
slots on the left and right-hand top of the dishwasher collar as
shown.
Install mounting bracket
Tabs must point to. the right
2.
Insert the bracket into the slot on the collar. Using a pair of
pliers, bend the tab down to secure the bracket in place.
Repeat this step for the other side.
NOTE:
Do not attach the dishwasher. This will be done later.
Option 2, Dishwasher with Stainless Steel Tub Side
Attachment
(for marble, granite or other hard surface countertops)
NOTE: You must predrill pilot holes in cabinet to prevent splitting
the wood
before installing screws.
1.
Remove the brackets from the parts package.
2.
Break off the end of the bracket along the scored line.
Score line
3.
With another person holding the dishwasher to avoid it from
tipping, open dishwasher door, and place towel over pump
assembly and spray arm of dishwasher. This will stop screws
from falling into pump area when securing dishwasher to
cabinet.
4.
Push the plastic buttons out of the side of the tub.
NOTE: Save the buttons to cover the holes after dishwasher is
installed.
Install plastic button
5.
Push bracket into slot on the side of dishwasher, and bend tab
in toward the side of the dishwasher so that it keeps the
bracket in place.
NOTE:
Do not attach the dishwasher. This will be done later.
Bend tab - side mount
oN
BY
Option 3, Dishwasher with Plastic Tub Side Attachment
(for marble, granite or other hard surface countertops)
Order Mounting B Bracket Kit Part Number 8212560.
Move
Dishwasher
Close to Cabinet
Opening
1 | Stand dishwasher upright
Using two or more people, stand dishwasher upright.
NOTE: Do not install kickplate until instructed to do so.
13
Publicité
