Suntec Wellness KLIMATRONIC Freeze 7.000 Eco R290 Mode D'emploi page 17

Frost protection
•
In cooling, dehumidifying and sleeping modes, the unit has an automatic frost protection function
designed to protect the unit at low temperatures. The device also has an automatic defrosting function.
Emptying of the water tank
•
As soon as the water tank is full, the "WF" blinks on the display, the
standby mode automatically turns on, it will sound the warning alarm and
all the buttons will be locked until the tank is emptied.
•
Turn off the power and unplug the power cord. To empty of the water tank
you need to remove the rubber stopper on the bottom of the unit and let
the water leak into a container. Once you reboot the device, it will work
normally.
•
Continuous drainage (only in dehumidifying mode): Remove the rubber
stopper on the bottom of the unit and connect the drainage hose to the
opening. Let the water leak into a container (pic.5).
Cleaning
•
Always disconnect the appliance from the power outlet and let it cool before cleaning. Never immerse
the appliance in water to prevent electric shocks.
•
Wipe over the exterior of the appliance with a soft wet cloth and neutral detergent and then wipe dry
with a dry cloth.
•
Do not use gasoline or other chemicals to clean the unit.
•
Clean the dust filter once every two weeks. Clean the dust filter
with neutral detergent and about 40°C water. Rinse off any
detergent, then let it air-dry before inserting it back into the unit
(pic.6).
•
If you do not use the unit for a longer time, empty the water tank
completely. Make sure that the unit is disconnected from the
power supply and that it is clean. Keep the unit covered in a dry
place.
Troubleshooting
Problem
1. Unit does not start
when pressing
"POWER".
2. It's not cool
enough.
3. Unit is too loud.
Possible causes
Water tank is full and indicating light
"W.F." is blinking.
Room temperature is lower than the set
temperature during operation mode
cooling.
The ambient temperature is too low or
too high.
In dehumidification mode, the ambient
temperature is too low.
Doors or windows are not closed.
There are heat sources in the room.
Exhaust hose is not installed or blocked.
Set temperature is too high.
Air inlet is blocked.
The ground is not even and flat enough
Pic.6
Suggestions
Empty the water tank.
Reset the temperature.
We recommend the operaiton at 7-35°C.
The ambient temperature needs to be
higher than 17°C.
Close all doors and windows.
Remove the heat sources if possible.
Install the exhaust hose and make sure
that the hose is clean and not blocked by
any objects.
Reset the temperature.
Clean the air inlet
Place the unit on an even and flat surface.
Pic.5