Artsound ART 4.1 Mode D'emploi page 55

F Formatting
Press 'OK' to start formatting. This function works only if you've connected the Wipod to a
computer via a USB cable. This function will only format the Flash memory of the Wipod. All
files will be deleted from the Flash memory. The internal firmware will NOT be deleted. After
formatting, the Wipod is ready for use again.
G Factory link
Before reading further – this coupling has already been done for you and you only need to do
it if the Receiver-box does not react to commands from the Wipod. Or if you want to couple
another (new) Wipod to the Receiver-box.
Choose 'Factory Link' and press OK to go to the menu. With this function you can couple a
Wipod with a Receiver-box. The screen below will appear.
S ：A00E1437BO
D ：A00A5235DE (address code of the Receiver-box)
(both devices have a different address and are thus not coupled.)
1 Get Address and Save Address:
Pull the plug (of the Receiver-box) out of the mains socket for a few seconds and then
plug it back in again. Now press (within 5 seconds) Get Address and then Set
Address. You now see that both devices have the same address and are thus
coupled. You can now operate the Receiver-box with the Wipod.
2 Random address:
Pull the plug (of the Receiver-box) out of the mains socket for a few seconds and then
plug it back in again. Press "Random address" five times so that the Receiver-box
generates a random address. This function makes sure that every Receiver-box gets a
random address, otherwise it might happen that one Wipod controls two (or more)
Receiver-boxes at the same time.
Note: You (actually) never need to use this function. A random address was already
chosen for the Receiver-box during production.
3 Test tone:
With this function you can test whether the Wipod and Receiver-box are actually
coupled. By pressing "Test Tone", the Receiver-box will emit a signal (tone). This
indicates that both devices are correctly coupled.
If you've performed the above steps correctly, the devices will have been successfully
coupled.
S ：A00A5235DE (address code of the Wipod)
D ：A00A5235DE (address code of the Receiver-box)
(both devices now have the same address and are thus correctly coupled.)
(address code of the Wipod)
55