Volume Control - Artsound ART 4.1 Mode D'emploi

D Set AUX
For you to understand this function properly, we will first give an example.
Example:
You want the sound from a TV to run via this Wipod system. You've connected the TV to AUX I
of the Receiver-Box. To be able to hear the sound from the TV, you need to choose AUX I at
AUX (in the Home menu). The Receiver-Box will now feed the sound from the connected
device (the TV) to AUX I. You can now operate the TV on Infrared.
It can also happen faster:
Choose 'TV' in the 'Settings/System/Set AUX ' menu. The screen below will appear.
Set AUX:
Here you can indicate which AUX the Receiver-Box must select if you choose 'TV' at AUX (in
the above example AUX I). Select the AUX you want (AUX I, AUX II, or No AUX.)

Volume Control:

You can choose to train the 'Volume +' and 'Volume –' of the TV into the Wipod. You then
control the volume of the TV with the Wipod. The volume of the Receiver-Box will not increase
or lower. If you want that, select 'Ext'.
If you've the volume on your TV set at a fixed level, select 'Int' here. Here you are saying that
the volume of the Receiver-Box should change if you press 'Volume +' or
'Volume –' on Infrared. If you've chosen 'Int', it will not be possible to train in these buttons.
E Update
Press 'OK' to go to the menu. You can now update the firmware on your Wipod. At
www.artsound.be
of Wipod.
Download that firmware and copy it to the Wipod (via USB connection). Now select System
Update and press 'OK'. The Wipod will work in the latest firmware. After a few minutes the
Wipod is ready for use again. The saved music files will not have been deleted. Then remove
the update file from the Wipod.
Note: Make sure the Wipod is fully charged (or is connected to the adapter or computer).
Under no circumstances switch the Wipod off while updating.
AUX I will be activated directly.
you can see what the most current version is that is available for your model
54