Artsound ART 4.1 Mode D'emploi page 53

C Bluetooth (Bluetooth connection between Wipod and Receiver-Box)
Press 'OK' to go to the menu. The following screen appears:
1 Connect:
Couple the Bluetooth transmitter (Wipod) and Bluetooth receiver (in Receiver-box)
with one another (this function will only work if pairing has already taken place).
2 Wipod status:
Check the status of the Bluetooth transmitter (Wipod). You hear a test tone.
3 AMP status:
Check the status of the Bluetooth receiver (Receiver-box). You hear a test tone.
4 Pair:
At the moment you press on 'Pair', both devices (Wipod and Receiver-Box) will go into
the pairing mode. After 60 seconds, that mode will be switched off automatically. If
pairing succeeds, you will see 2x AUDIO at the bottom of the screen. If no successful
pairing has taken place after 60 seconds, you need to first press "Clear Connect"
before pressing "Pair" again.
Note: During pairing you need to switch other Bluetooth devices off. This pairing has (in
principle) already been done for you and you do not need to do it again.
5 Clear Connect:
Remove devices that (correctly or incorrectly) are coupled.
53