Num'axes Canifugue Mix FUG1031 Guide D'utilisation page 26

Once the loop is completed and you are back to the transmitter, strip the two ends of the wire to connect them to the supplied
transmitter connector (connect each wire with each connector screw). Then, insert this connector into the antenna socket
located on the transmitter (ref. Diagram 1 – the connector is slanted. If you can't insert it, turn it 1/2 turn).
• Flags
The flags are a temporary visual aid for your dog during the training process. They enable your dog to visualize the area where
he can move freely and the boundaries he must not cross.
We recommend installing the flags at the inner edge of the warning zone at short intervals. Do not place the flags at the
antenna wire.
Once your dog is familiar with the boundaries, the flags can be gradually removed.
• Layout of your installation
Before starting the installation of your pet fencing system, it may be useful to draw a layout of the installation.
Once the installation is completed, note the location of the wire connectors on the layout you drew for future reference. In
case of connection default, you will find them more easily.
Diagram 4 – Sample installation
AUTOMATIC SYSTEM
Antenna wire
As soon as the animal wearing a collar
enters the protected area, he is warned by
2 m between
beep sounds.
both wires
If he continues to move forward, towards
Warning
the antenna wire, the collar emits
By twisting the outward strand with the inward
area
stimulations.
strand, wave emission is blocked and the
animal can move freely within this zone.
The antenna wire is placed on the ground,
buried or raised on an existing fence.
Stimulation
For the system to function, the wire must area
Transmitter
form a continuous loop.
Both wires (inward and outward) must be
Twisted wire
spaced 2 meters apart.
26
guide canifugue MIX FUG1031 - indD.indd 26 17/07/2019 12:20