Publicité
Les langues disponibles
Les langues disponibles
90530436 TR016 etc htrimmers
CAUTION: Do not use the trimmer for cutting stems greater than its capacity.
TR016, TR017 3/8 in.(5mm).
HT012, HT018 5/8 in.(8mm).
HT020, HT512, HT022 3/4 in.(19mm).
Use the trimmer only for cutting normal shrubbery found around houses and buildings.
4. LEVEL HEDGES (Figure 12) – To obtain exceptionally level hedges, a piece of
string can be stretched along the length of the hedge as a guide.
5. SIDE-TRIMMING HEDGES (Figure 13) – Begin at the bottom and sweep up.
:
WARNING
TO GUARD AGAINST INJURY, OBSERVE THE FOLLOWING:
•
READ INSTRUCTION MANUAL BEFORE USING, SAVE INSTRUCTION
MANUAL.
•
KEEP HANDS ON HANDLES. DON'T OVERREACH.
•
DO NOT USE UNDER WET CONDITIONS.
•
DO NOT USE WITH DAMAGED EXTENSION CORD.
•
DO NOT UNPLUG OR STORE WITH SWITCH LOCKED ON.
DANGER: KEEP HANDS AWAY FROM BLADES.
CAUTION: BLADE COASTS AFTER TURN OFF.
Problem
•Unit will not start.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
MAINTENANCE
The cutting blades are made from high quality, hardened steel and with normal usage,
they will not require resharpening. However, if you accidentally hit a wire fence, stones,
glass or other hard objects, you may put a nick in the blade. There is no need to remove
this nick as long as it does not interfere with the movement of the blade. If it does
interfere, unplug unit and while wearing proper eye protection use a fine toothed file or
sharpening stone to remove the nick.
If you drop the trimmer, carefully inspect it for damage. If the blade is bent, housing
cracked, or handles broken or if you see any other condition that may affect the
trimmer's operation, contact your local Black & Decker Service Center for repairs
before putting it back into use.
Fertilizers and other garden chemicals contain agents which greatly accelerate the
corrosion of metals. Do not store the tool on or adjacent to fertilizers or chemicals.
With the unit unplugged, use only mild soap and a damp cloth to clean the tool. Never
let any liquid get inside the tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment should be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
3/17/08
8:36 AM
Page 7
Troubleshooting
Possible Cause
Possible Solution
• Cord not plugged in.
• Plug in cord.
• Circuit fuse is blown.
• Replace circuit fuse.
• Circuit breaker
• Reset circuit breaker.
is tripped.
• Cord or switch is
• Have cord or switch
damaged.
replaced at Black & Decker
Service Center or Authorized
Servicer.
7
Publicité
