Sony BRAVIA KD-75X750H Manuel De Référence page 8

KD-55X750H
Wall-Mount Bracket
Note
• If using an electric screwdriver, set the torque at
approximately 1.5 N·m {15 kgf·cm}.
Detaching the Table-Top Stand from the
TV
KD-75X750H / 65X750H
1
Remove one side of the Table-Top
Stand at a time. Firmly hold the
Table-Top Stand securely with both
hands while the other people lift up
the TV.
8
US
Screw
2
Repeat the previous step and
remove the other side of the
Table-Top Stand.
Note
• Three or more people are required to detach the
Table-Top Stand.
• Be careful not to use excessive force while
detaching the Table-Top Stand from the TV as it
may cause the TV set to fall resulting in personal
injury or physical damage to the TV.
• Take care when handling the Table-Top Stand to
prevent damage to the TV.
• Be careful when lifting the TV as the Table-Top
Stand is detached, the Table-Top Stand may
topple over and cause personal injury.
• Take care when removing the Table-Top Stand
from the TV to prevent it from falling over and
damaging the surface that the TV is sitting on.
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
• Be sure the TV is vertical before turning on. To
avoid uneven picture uniformity do not power
on the TV with the LCD panel facing down.
KD-55X750H
Note
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
• Be sure the TV is vertical before turning on. To
avoid uneven picture uniformity do not power
on the TV with the LCD panel facing down.
• When attaching the Table-Top Stand again, be
sure to fasten the screws (previously removed)
to the original holes on the rear of the TV.