Publicité
Les langues disponibles
Les langues disponibles
Recommended Measures to Secure the
TV
Consider the following measures when securing your TV to
a Stand (not supplied).
1
Secure the Stand for the TV.
Make sure the Stand can adequately support the weight
of the TV. Use two angle braces (not supplied) to secure
the Stand. For each angle brace use the appropriate
hardware to:
• Attach one side of the angle brace to the wall stud.
• Attach the other side to the Stand.
2
Secure the TV to the Stand.
Use the optional hardware listed as follows (not
supplied):
• M6 machine screws (screwed into the TV's rear cover).
• A screw or similar (attach it to the Stand).
• Rope or chain (strong enough to support the weight of
the TV). Make sure that there is no excess slack in the
rope or chain.
Screw (not supplied)
The length of the M6 machine screw differs depending
on the rope or chain diameter. Please refer to below
illustration.
8 mm – 12 mm
Screw (M6)
Rope or chain
TV's rear cover
4
US
Angle brace
(not supplied)
Stand
Screw hole on the rear cover
M6 machine screw
(not supplied)
Rope or chain
(not supplied)
1.5 N·m
{15 kgf·cm}
3
Anchor the TV to the wall by using bolts, wall anchor and
chain (or rope).
Wall-mount holes
M6 eye bolts (not supplied)
Please refer to below illustration for M6 eye bolt length.
8 mm – 12 mm
TV's rear cover
Note
• Your TV is shipped with screws attached to the rear of the
TV depending on the TV model. (They are fastened in the
screw holes for wall mounting.) Be sure to remove the
upper two screws prior to anchoring the TV to a wall.
• Securing the TV to the Stand without securing the TV and
the Stand to the wall provides minimum protection
against the TV toppling over. For further protection, be
sure to follow the three measures recommended.
Rope or chain
(not supplied)
Wall-anchor
(not supplied)
M6 eye bolt
Publicité
