Fulgor Milano FCO 9013 TM Instructions Pour L'installation Et L'utilisation page 48

10 - System Setting
EN
With the oven on, select the icon
to enter the SETTINGS menu. This menu permits setting a number of
parameters or special functions. It also permits accessing the error
events list.
1. Press the keys to select the sub menu and confirm with the
key.
2. Use this menu to change the following settings:
Press the keys to select the item to be set or to be displayed
from among the three available ones and confirm with the
EVENT LOGS
MAIN VOLTAGE
DEMO
Event Log
The menu permits checking any recorded errors. These codes can be
notified to the after-sales service.
01 12/11/2015 07:06 CODE: F10305
02 17/11/2015 13:17 CODE: F10305
14
and confirm with the key
SETUP
SERVICE
SYSTEM
OM 15
EVENT LOGS
Demo
The purpose of this function is to set the DEMO mode, which makes the
oven useless for cooking but automatically performs a demonstration
of functions.
1. Press the keys
2. Confirm with the
3. Press the key.
After about 30 seconds, the oven starts to operate in this mode.
To temporarily stop the DEMO function, simply keep any key pressed
for a few seconds until the oven switches to standby. To start it again,
press the key.
To disable the function, enter the DEMO display page and set OFF.
Confirm using the
NOTE Once set, the function remains enabled even if the oven is
disconnected from the power mains.
key.
to select the item ON.
key.
key.
DEMO
ON