GARDEO PRO GPDCBT52 Traduction Des Instructions Originales page 98

OPERATIONS
ENGINE STARTING AND
STOPPING PROCEDURES
switch
STARTING COLD ENGINE
Move the stop switch to "1"
position.
13. Give a gentle push on the primer pump
repeatedly (7-10times) until fuel comes
10X
into the primer pump.
14. Pull choke lever up to close choke.
15. Pull starter handle until engine flash. fires.
16. Push choke lever down to open choke (excessive cranking with choke lever will cause
flooding engine making it difficult to start).
17. Pull starter handle until engine starts.
18. Allow engine to warm up for a few minutes before using.
STARTING WARM ENGINE
 If fuel tank was not run dry, pull starter. one to three times and should start.
DO NOT USE CHOKE
 If fuel tank was run dry, after refilling repeat steps 3 thru 7 in. STARTING COLD
ENGINE.
STOPPING THE ENGINE
 Move switch to "o" position
15