Publicité
Les langues disponibles
Les langues disponibles
SCYTHING WEEDS This is cutting by
swinging the blade in a level arc. It can
quickly clear areas of field grass and
weeds. Scything should not be used to
cut large, tough weeds or woody
growths.
NOTE
Do not use a brush blade to cut trees which
exceed a diameter of 1/2 to 3/4 inches.
Scything can be done in both directions, or just in one way which
results in the debris being thrown away from you.
That is using the side of the blade that it is rotating away from
you. Tilt down the blade slightly on this same side. You will be hit
by some debris if you scythe in both directions.
Cut only with the side of the blade that the debris is moving away
from you.
If kickback occurs, the blade may be dull, or the material so thick
and hard that you should use other tool instead of this machine.
Do not force the blade to cut. Do not change the angle of cut
after into the wood. Avoid using any pressure or leverage which
could cause the blade to bind or crack.
WARNING
Use the shoulder harness at all times
adjust both harness and harness clamp
on the unit so that the unit hangs a few
inches above ground level .The cutting
head and the metal debris shield should
be level in all directions. Harness the
unit on the right side of your body.
12
△
DANGER
,!
Publicité
