GARDEO PRO GPDCBT52 Traduction Des Instructions Originales page 91

REPLACE THE METAL BLADE TO
STRING HEAD
Disassembly metal blade
1, Align the hole on the gear box to the slot on the flange washer
2, Use pin to through the hole and slot and hold the flange washer
3, Loose the nut and remove the metal blade and cup washer
Assembly string head
4, Install the flange washer and cup washer on the spline shaft.
5, Align the hole on the gear box to the slot on the flange washer.
6, Use pin to through the hole and slot and hold the flange
washer.
7, Install the string head and tighten it
△
WARNING CAUTION
,!
EXCESSIVE VIBRATION.
STOP ENGINE IMMEDIATELY
Excessive vibration of blade means that it is not properly installed-stop engine immediately and
check blade. Blade not properly installed will cause injury.
.
8
WARNING
The edge of metal blade is sharp.
You need to wear gloves when
you installing or removing the
metal blade.