GARDEO PRO GPDCBT52 Traduction Des Instructions Originales page 89

INSTALLING PLASTIC GUARD
1, Movening the 2 screw from the guard
2, Aim at the thread hole with the clamp and guard
3, Tighten the screw
INSTALLING HARNESS
1, Adjust the harness hanger in a comfortable
Piston.
2, Buckle the harness at the hanger
clamp
screw
Harness hanger
Harness
ADJUSTING THE HARNESS
Note: Always use the harness when using the brush cutter.
Once you have started the engine and the engine is at idle speed,
attach the harness. Stop the engine before removing the harness.
To prepare for any event, the use of a harness: practice getting out of
the machine quickly. To avoid damage, do not throw the machine on
the floor during this exercise.
WARNING:
Loss of machine control can result in serious injury or death.
6
guard
clamp