Franke Crystal CR 913 M Manuel D'installation page 5

EN
InstallatIon
Installation must be carried out in compliance with current standards and
regulations.
Installation must only be carried out by specialised and licensed personnel.
Cabinet requirements
For fitted units, the components (plastic materials and veneered wood) must be
assembled with heat-resistant adhesives (min. 100°C): Unsuitable materials and
adhesives can result in warping and detachment.
The cabinet for the oven must allow sufficient room for the electrical connections of
the oven.
The cabinet for the oven must be sturdy enough to withstand the weight of the oven.
The oven must be securely installed in the recess. The oven can be installed in a
column housing unit or below the countertop of a modular unit, provided sufficient
ventilation is guaranteed.
Electrical connection
FRANKE ovens are supplied with a three-pole power cable with free terminals.
The connection polarities of the free
terminals are respected:
Brown = Line
Blue = Neutral
Yellow / Green = Earth
Make sure the characteristics of the household electrical system (voltage,
X X
maximum power and current) are compatible with those of the oven.
If the oven is to be permanently connected to the power supply:
Install a device that enables disconnection from the power supply, with a contact
X X
opening distance (3 mm) that ensures complete disconnection in category III
overvoltage conditions.
Ensure the following:
X X
– The plug and the socket are suitable for a 16 A current.
– The plug and the socket can be easily reached and are positioned so that no live
part is accessible when inserting or removing the plug.
– The oven does not rest against the plug when installed in the cabinet.
– A 3 x 1.5 mm
CR 913 M / CR 982 M
H05V2V2-F type cable is used when replacing the power cable.
2
blue
yellow/green
brown
– 4 –