Garland CRUMMER 1220 QGW Manuel D'instructions page 38

English
Maintain a good balance on both feet. Do not lean on
the machine.
Maintain yourself well clear of the exit area whilst the
machine is working.
If the blades hit a strange object (any other object
different to wood) or if the machine starts to make
strange noises and/or it vibrates in an abnormal way,
stop the engine so that the blades stop turning. Take
the machine to your nearest service agent for repair.
If the machine gets stuck, you must stop it and wait
for the blades to stop turning.
The machine is designed only for outdoor use. Avoid
using the machine in outdoor areas with a high
probability of exhaust fumes.
The machine must be used by only one person at a
time.
Never insert your hands in the entry chute until the
machine has been stopped and the blades have
stopped rotating.
The pieces of wood that might have got stuck
transversally must only be removed when the machine
has been stopped and the blades have stopped
rotating.
Transport of the machine should be carried out by two
persons to avoid possible injuries.
Two blades opposite on a rotor and another counter
blade on the chassis.
The use of working gloves,
ear protection and working
glasses is mandatory.
6.4.2. STARTING THE ENGINE
Before starting engine make sure check the engine oil
and fuel tank before starting the engine.
6.4.2.1. ELECTRIC AND MANUAL COLD START
A. Turn the engine switch with the ignition key in the
ON position.
A. Place the ON/OFF switch in the "ON" position.
B. Place the fuel tap in the open position.
C. Place the air lever in the Closed position
38/148
CIRCUIT
PROTECTOR
ON OFF
.