Candy CTS6ESMX Mode D'emploi page 9

and power button
lights. Indicator light of lamp button
recycle like this.
4. Press the (High) button once, motor runs on high speed, the indicator light of
high button
motor will stop. Indicator light of high button and power button will be off,and run by
circle.
5. Press the (Mid) button once, motor runs on middle speed, the indicator light of
middle button
the motor will stop. Indicator light of middle button and power button will be off,and
run by circle.
6. Press the (low) button once, motor runs on low speed, the indicator light of low
button and power button
motor will stop. Indicator light of low button and power button will be off,and run by
circle.
7. Low speed, mid speed and high speed cannot work at the same time. When hood
is on high speed, press low speed, it will turn to low speed at once; when it is in low
speed, press middle speed, it will turn to middle speed immediately, and so on.
TROUBLESHOOTING
Fault
Light on, but motor
does not work
Light does not
work, motor does
not work
Oil leakage
Lights not working
Insufficient suction
will lit on. Press lamp button
and power button
and power button
Possible Cause
Fan switch turned off
Fan switch failed
Motor failed
House fuses blown
Mains power cable is loose or
disconnected
One way valve and the outlet
are not tightly sealed
Leakage from the connection of
chimney and cover
Broken or faulty bulbs
The distance between the
cooker hood and the gas top is
too far
and power button
will beam. Press high button
will beam. Press middle button
will beam. Press low button
9
again to turn off the
will be off. And
again and the
again and the
Solution
Select a fan switch position.
Contact service center.
Contact service center.
Reset/Replace fuses.
Refit mains power cable to
power outlet.
Switch power outlet on.
Take down the one way valve
and seal with sealant.
Take chimney down and seal.
Replace bulbs as per this
instruction.
Refit the cooker hood to the
correct distance.
again and