Publicité
INSTALLATION
reached. With this installation you have to be aware
of the snowdrift line, dead grass, and leaves. We
recommend a 3ft (0.91m) minimum vertical rise on
the inside or outside of the house. The "through the
wall" installation is the least expensive and simplest
installation. Never terminate the end vent under a
deck, in an alcove, under a window, or between two
windows. We recommend Simpson Dura-Vent® or
Metal-Fab® kits.
THROUGH THE ROOF/CEILING
INSTALLATION
• When venting the heater through the ceiling, the
pipe is connected the same as through the wall,
except the clean-out tee is always on the inside
of the house, and a 3" (76 mm) adapter is added
before the clean-out tee.
• You must use the proper ceiling support
flanges and roof flashing (supplied by the pipe
manufacturer; follow the pipe manufacturer's
directions). It is important to note that if your
vertical run of pipe is more than 12ft (3.7m), the
pellet vent pipe size should be increased to 4" (102
mm) in diameter.
• Do not exceed more than 4ft (1.22m) of pipe on a
horizontal run and use as few elbows as possible. If
an offset is required, it is better to install 45-degree
elbows rather than 90-degree elbows.
WARNING:
YOU MAY WANT TO LOCATE ANY UTILITIES
OR OBSTACLES INSIDE THE WALL BEFORE
ATTEMPTING THIS INSTALL. MAKE SURE TO
KEEP IN MIND YOUR UNIT'S CLEARANCE
REQUIREMENTS.
1.
Mark the area and then cut the wall for vent
installation if needed.
2. Install the wall thimble as specified by the
manufacturer (wall thimble sold separately).
3. Install venting.
VENTING YOUR PELLET STOVE INTO
AN EXISTING CLASS A 6" CHIMNEY
SYSTEM
IF YOU ARE INSTALLING YOUR PELLET STOVE
AS A REPLACEMENT TO AN EXISTING WOOD
STOVE, YOU CAN INSTALL YOUR PELLET
STOVE USING THE EXISTING CLASS A 6"
VENTING SYSTEM.
1.
You must have the existing chimney system
cleaned and/or inspected by a qualified chimney
sweep before proceeding with the installation
of your pellet stove.
2. To the right is an example of an installation
using part number 860001, 3-6" transition into
6" connector pipe (the illustration is only an
example). Please conform to any local building
codes or regulations having jurisdiction before
you have a qualified installer proceed with this
installation.
Ceiling
Support
To Stove
11
© 2024 United States Stove Company
IMPORTANT:
Existing Class 'A'
6" Chimney System
Support
Bracket
3" to 6" Pipe
Adapter
3" PL Vent
Clean Out Tee
Publicité
