Publicité
Liens rapides
Owner's Instruction and Operation Manual
Model Number:
AP5617-W
Report #: F22-777
Certified to ASTM E1509-2022 and Certified to
CAN/ULC S627:2023; Complies to CAN ICES-3(B)/
NMB-3(B); Contains IC:23243-WBR1DIPEX
Mobile Home / Transportable Building Approved
* All Pictures In This Manual Are For Illustrative Purposes Only. Actual Product May Vary.
Save These Instructions In A Safe Place For Future Reference.
SAFETY NOTICE: If this heater is not properly installed, a house fire may result.
For your safety, follow the installation instructions. Never use make-shift
compromises during the installation of this heater. Contact local building or
fire officials about permits, restrictions and installation requirements in your
area. NEVER OPERATE THIS PRODUCT WHILE UNATTENDED.
CAUTION! Please read this entire manual before you install or use your new room
heater. Failure to follow instructions may result in property damage, bodily injury,
or even death. Improper Installation Will Void Your Warranty!
U.S. Environmental Protection Agency
Certified to comply with 2020 particulate
emissions standards.
THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE.
© 2024 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380
R
CALIFORNIA PROPOSITION 65 WARNING:
This product can expose you to chemicals including carbon
monoxide, which is known to the State of California to cause
cancer, birth defects, and/or other reproductive harm. For
more information, go to
853997E-1904N
www.P65warnings.ca.gov
Ph. 800-750-2723
Publicité
Manuels Connexes pour United States Stove Ashley AP5617-W
Sommaire des Matières pour United States Stove Ashley AP5617-W
- Page 1 State of California to cause emissions standards. cancer, birth defects, and/or other reproductive harm. For more information, go to www.P65warnings.ca.gov THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE. © 2024 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380 Ph. 800-750-2723...
- Page 2 Text to 423-301-5624 or; You can also register your product online at Email us at: www.usstove.com/support/product-registration / OR by downloading the US Stove Company customerservice@usstove.com app available for iOS and Android. © 2024 United States Stove Company...
- Page 3 Signed: ___________________________________ Print Name: ______________________________ Date: _____________ Home Owner: RETAIN THIS INFORMATION FOR FUTURE REFERENCE © 2024 United States Stove Company...
- Page 4 5 Pin Main Wiring Harness. Connect the 4 Pin Wiring Harness to the bottom left- hand corner of the control panel. 5 Pin Main Wiring Harness 4 Pin Fuel Sensor 7 Pin Com Cable © 2024 United States Stove Company...
- Page 5 Your heater should be installed by a qualified NFI THE HEATER. DO NOT ROUTE THE CORD IN (US) or WETT (Canada) technician. To find the FOOT TRAFFIC AREAS OR PINCH THE CORD nearest qualified installer, go to: UNDER FURNITURE. https://nficertified.org, https://www.wettinc.ca/ © 2024 United States Stove Company...
- Page 6 Canadian Installations require a Ceiling Height To Floor 1524 minimum of 18” [458 mm] beyond the front of the Ceiling Height To Appliance unit and 8” [204 mm] beyond each side of the unit. © 2024 United States Stove Company...
- Page 7 OF THE MOBILE HOME / TRANSPORTABLE BUILDING FLOOR, WALL, AND CEILING/ROOF MUST BE MAINTAINED. WHEN INSTALLED IN A MOBILE HOME / TRANSPORTABLE BUILDING, STOVE MUST BE GROUNDED DIRECTLY TO THE STEEL CHASSIS AND BOLTED TO THE FLOOR. © 2024 United States Stove Company...
- Page 8 © 2024 United States Stove Company...
- Page 9 G. Minimum 2-foot (0.61m) clearance below eves HORIZONTAL EXHAUST VENT or overhang. INSTALLATION H. Minimum 1-foot (0.3m) clearance horizontally Locate your pellet stove in a location which from combustible wall. meets the requirements of this manual, but © 2024 United States Stove Company...
- Page 10 3ft (0.91m) to get above the snowdrift line. vent cap is recommended. This same installation can be used if your heater is below ground level by simply adding the clean-out section and vertical pipe inside until ground level is © 2024 United States Stove Company...
- Page 11 Support 2. Install the wall thimble as specified by the Bracket manufacturer (wall thimble sold separately). 3. Install venting. 3” to 6” Pipe Adapter To Stove 3” PL Vent Clean Out Tee © 2024 United States Stove Company...
- Page 12 ON/OFF HEAT MODE sequence. The fuel feed system will stop pulling (POWER) RANGE fuel from the hopper and, once the fire goes out and the heater cools down, the fans will stop running. © 2024 United States Stove Company...
- Page 13 We cannot accept ATTENTION: responsibility for damage due to poor quality pellet. THIS APPLIANCE IS DESIGNED FOR THE USE OF PELLETIZED FUEL THAT MEET OR EXCEED THE STANDARD SET BY THE PELLET FUEL INSTITUTE (PFI). © 2024 United States Stove Company...
- Page 14 Setting 4 will give you a medium high be able to restart the stove. burn and setting 2 will give you a medium low burn. © 2024 United States Stove Company...
- Page 15 The stove will shut down and show • WE RECOMMEND THAT YOU NOT LET THE “E2” on the two digit display. The stove has to fully HOPPER DROP BELOW 1/4 FULL. shut down before restarting. © 2024 United States Stove Company...
- Page 16 Some regular vacuum cleaner (i.e. shop vacs) may leak ash into the room. DO NOT VACUUM HOT ASH. WARNING: FAILURE PROPERLY MAINTENANCE THE CLEAN OUTS WILL RESULT IN POOR PERFORMANCE OF THIS STOVE. © 2024 United States Stove Company...
- Page 17 • Enter the 6 digit verification code that was sent to the previously entered email address. • Provide access to the two permissions requested. • Allow notifications through the phones settings. • The app is ready to add the unit. © 2024 United States Stove Company...
- Page 18 The app and unit are now ready for use. Device Select Device Name & Screen Device Sharing Settings Current Room Temperature Temperature Adjuster Stove Setting Decrease Increase Temperature Temperature Setpoint Setpoint Mode Power ON/OFF Heat Range © 2024 United States Stove Company...
- Page 19 If combined with combustible substances, a qualified person annually or per ton of pellets ashes, and embers may ignite. to determine if a creosote or fly ash build-up has © 2024 United States Stove Company...
- Page 20 The exhaust system should be thoroughly cleaned. We recommend using a high-quality glass cleaner. Should a buildup of creosote or carbon accumulate, you may wish to use 000 steel wool and water to © 2024 United States Stove Company...
- Page 21 200 mm (8 in) beyond the appliance on other DO NOT INSTALL IN AN ALCOVE sides, shall be protected by a continuous, durable, DO NOT INSTALL IN ANY FIREPLACE © 2024 United States Stove Company...
- Page 22 High Limit Switch is malfunctioning. switch. ATTENTION: THIS WOOD HEATER NEEDS PERIODIC INSPECTION AND REPAIR FOR PROPER OPERATION. IT IS AGAINST FEDERAL REGULATIONS TO OPERATE THIS WOOD HEATER IN A MANNER INCONSISTENT WITH OPERATING INSTRUCTIONS IN THIS MANUAL. © 2024 United States Stove Company...
- Page 23 (you may want to remove the hose entirely off the stove and the air switch first and make sure it is clear). If you hear a click, the air switch is working. BE CAREFUL TOO MUCH VACUUM CAN DAMAGE THE AIR SWITCH. © 2024 United States Stove Company...
- Page 24 The control board is not sending power to There should be a 5-volt (approximately) current going the POF thermodisc or other auger system to the POF thermodisc after the stove has been on for 10 components. minutes. © 2024 United States Stove Company...
- Page 25 Remove the auger motor from the auger shaft and try to The auger motor has failed. run the unit. If the motor will turn the shaft is jammed on something. If the motor will not turn, the motor is bad. © 2024 United States Stove Company...
- Page 26 Circuit board malfunction. the control board is fine. If there is NOT power being sent to the blower when it shuts off during operation, then you have a bad control board. © 2024 United States Stove Company...
- Page 27 Auger Motor Email to: parts@usstove.com IN ORDER TO MAINTAIN WARRANTY, COMPONENTS MUST BE REPLACED USING USSC PARTS PURCHASED THROUGH YOUR DEALER OR DIRECTLY FROM USSC. USE OF THIRD PARTY COMPONENTS WILL VOID THE WARRANTY. © 2024 United States Stove Company...
- Page 28 Part numbers and descriptions can be found in the “Repair Parts” section of this manual. Once this information has been gathered you can contact customer service by phone 1-800-750-2723 Ext 5051 or Email parts@usstove.com. Model Information Model Number Serial Number © 2024 United States Stove Company...
- Page 29 Engineer Name: _______________________________ Engineer Name: _______________________________ License No.: ____________________________________ License No.: ____________________________________ Company: _____________________________________ Company: _____________________________________ Telephone No.: _________________________________ Telephone No.: _________________________________ Stove Inspected: Chimney Swept: Stove Inspected: Chimney Swept: Items Replaced: _______________________________ Items Replaced: _______________________________ © 2024 United States Stove Company...
- Page 30 NOTES © 2024 United States Stove Company...
- Page 31 NOTES © 2024 United States Stove Company...