Publicité
Liens rapides
Owner's Instruction and Operation Manual
Model Number:
KP5513
Report Number: F21-735
Certified to ASTM E1509-12 (2017)
and Certified to ULC-S627-00-REV1
Mobile Home Approved
* All Pictures In This Manual Are For Illustrative Purposes Only. Actual Product May Vary.
Save These Instructions In A Safe Place For Future Reference.
SAFETY NOTICE: If this heater is not properly installed, a house fire may result. For
your safety, follow the installation instructions. Never use make-shift compromises
during the installation of this heater. Contact local building or fire officials about
permits, restrictions and installation requirements in your area. NEVER OPERATE
THIS PRODUCT WHILE UNATTENDED.
CAUTION! Please read this entire manual before you install or use your new room
heater. Failure to follow instructions may result in property damage, bodily injury, or
even death. Improper Installation Will Void Your Warranty!
U.S. Environmental Protection Agency
Certified to comply with 2020 particulate
emissions standards.
THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE.
© 2022 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380
R
CALIFORNIA PROPOSITION 65 WARNING:
This product can expose you to chemicals including carbon
monoxide, which is known to the State of California to cause
cancer, birth defects, and/or other reproductive harm. For
more information, go to www.P65warnings.ca.gov
853915B-2302L
Ph. 800-750-2723
Publicité
Manuels Connexes pour United States Stove KING KP5513
Sommaire des Matières pour United States Stove KING KP5513
- Page 1 State of California to cause emissions standards. cancer, birth defects, and/or other reproductive harm. For more information, go to www.P65warnings.ca.gov THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE. © 2022 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380 Ph. 800-750-2723...
- Page 2 This app is available only Text to 423-301-5624 or; on the App Store for iPhone and iPad. Email us at: Search US Stove. Save your receipt with customerservice@usstove.com your records for any claims. © 2022 United States Stove Company...
- Page 3 Declaration of Completion: As the qualified person responsible for the work described above, I confirm that the appliance as associated work has been installed as per manufacturer’s instructions and following any applicable building and installation codes. Signed: ______________________________________ Print Name: __________________________________Date: ______________ Home Owner: RETAIN THIS INFORMATION FOR FUTURE REFERENCE © 2022 United States Stove Company...
- Page 4 2. Unpack the top mount controls and ensure that the wiring harness shown is attached securely. 4. Secure the control panel to the top of the stove with two sheet metal screws. © 2022 United States Stove Company...
- Page 5 CORD IN FOOT TRAFFIC AREAS OR PINCH THE CORD UNDER FURNITURE. US Stove highly recommends your stove be installed by a qualified NFI (US) or WETT (Canada) technician. To find the nearest qualified installer, go to: https://nficertified.org, https://www.wettinc.ca/ © 2022 United States Stove Company...
- Page 6 (69FAK) which is necessary for a mobile home. reduction in clearance to combustibles may only be done You can purchase the 69FAK through your heater dealer. by means approved by a regulatory authority. © 2022 United States Stove Company...
- Page 7 • Vent must be 3 or 4-inch “PL” Vent and must extend IMPORTANCE OF PROPER DRAFT a minimum or 36” (914 mm) above the roof line of the © 2022 United States Stove Company...
- Page 8 G. Minimum 2-foot (0.61m) clearance below eves or sun deck or porch, narrow walkway, or any other location overhang. that can build up a concentration of fumes. Termination © 2022 United States Stove Company...
- Page 9 At this point, a 3ft (0.91m) (minimum) section of pipe should be added with a horizontal cap, which would complete the installation. A support bracket should be placed just below the termination cap or one every 4ft © 2022 United States Stove Company...
- Page 10 860001, 3-6” transition into 6” connector pipe. the illustration is only an example. Please conform to any local building codes or regulations having jurisdiction before you have a qualified installer proceed with this installation. © 2022 United States Stove Company...
- Page 11 • The levels of heat output will incrementally change on the bar graph starting from heat range “1” to heat range • When room temperature drops below desired set-point “5”. the stove will ramp back up until it reaches the desired temperature. © 2022 United States Stove Company...
- Page 12 5. Waste petroleum products, paints or paint thinners, increase heat output but may seriously impair the stoves or asphalt products; performance by generating considerable smoke. Do 6. Materials containing asbestos; not burn wet pellets. The stove’s performance depends © 2022 United States Stove Company...
- Page 13 Attempts from your U.S. Stove dealer. If glass is broken, follow to achieve heat output rates that exceed heater design these removal procedures: specifications can result in permanent damage to the © 2022 United States Stove Company...
- Page 14 A. To recognize an overheat situation in the stove and flashing “E3” shut down the fuel feed or auger system. REFUELLING B. In case of a malfunctioning convection blower, the high-temperature thermodisc will automatically © 2022 United States Stove Company...
- Page 15 • Heat Exchanger - There is a clean out plate on both Plate sides of the heat exchanger that need to be removed to clean fly ash out of the heat exchanger. The cleanouts are located inside the cabinet doors, on the lower © 2022 United States Stove Company...
- Page 16 The closed container of ashes should be placed on a certain conditions. The chimney connector and chimney noncombustible floor or on the ground, well away from should be inspected by a qualified person annually or per all combustible materials, pending final disposal. If © 2022 United States Stove Company...
- Page 17 CHECK & CLEAN THE HOPPER Check the hopper periodically to determine if there is any sawdust (fines) that is building up in the feed system or pellets that are sticking to the hopper surface. Clean as needed. © 2022 United States Stove Company...
- Page 18 Part numbers and descriptions can be found in the “Repair Parts” section of this manual. Once this information has been gathered you can contact customer service by phone 1-800-750-2723 Ext 5051 or Email parts@usstove.com. Model Information Model Number Serial Number © 2022 United States Stove Company...
- Page 19 If the other items check out OK, replace the high limit switch. ATTENTION: THIS WOOD HEATER NEEDS PERIODIC INSPECTION AND REPAIR FOR PROPER OPERATION. IT IS AGAINST FEDERAL REGULATIONS TO OPERATE THIS WOOD HEATER IN A MANNER INCONSISTENT WITH OPERATING INSTRUCTIONS IN THIS MANUAL. © 2022 United States Stove Company...
- Page 20 (you may want to remove the hose entirely off the stove and the air switch first and make sure it is clear). If you hear a click, the air switch is working. BE CAREFUL TOO MUCH VACUUM CAN DAMAGE THE AIR SWITCH. © 2022 United States Stove Company...
- Page 21 The control board is not sending power to the POF There should be a 5-volt (approximately) current going to the thermodisc or other auger system components. POF thermodisc after the stove has been on for 10 minutes. © 2022 United States Stove Company...
- Page 22 Remove the auger motor from the auger shaft and try to run the The auger motor has failed. unit. If the motor will turn the shaft is jammed on something. If the motor will not turn, the motor is bad. © 2022 United States Stove Company...
- Page 23 Circuit board malfunction. board is fine. If there is NOT power being sent to the blower when it shuts off during operation, then you have a bad control board. © 2022 United States Stove Company...
- Page 24 Check to see if a surge protector is being used on the stove. If not, recommend one to the consumer. High limit switch is malfunctioning. If the other items check out okay, replace the high limit switch. © 2022 United States Stove Company...
- Page 25 Bad Pellets. (Applies to GLASS “SOOT’S” UP AT You might also want to try a brand that is made from a different A VERY FAST RATE Only) type of wood (softwood vs. hardwood). Different woods have different characteristics when being burned. © 2022 United States Stove Company...
- Page 26 Ceramic Ignitor 88118 Ignitor Flange Gasket IN ORDER TO MAINTAIN WARRANTY, COMPONENTS MUST BE REPLACED USING ASHLEY PARTS PURCHASED THROUGH YOUR DEALER OR DIRECTLY FROM ASHLEY. USE OF THIRD PARTY COMPONENTS WILL VOID THE WARRANTY. © 2022 United States Stove Company...
- Page 27 WIRING DIAGRAM 7.5A 250V FUSE 1.25A 250V FUSE Ensure the wires are connected to the bottom two prongs of the hopper switch as shown. CORRECT WRONG © 2022 United States Stove Company...
- Page 28 NOTES © 2022 United States Stove Company...
- Page 29 Engineer Name: ____________________________________ Engineer Name: ____________________________________ License No.: ________________________________________ License No.: ________________________________________ Company: __________________________________________ Company: __________________________________________ Telephone No.: _____________________________________ Telephone No.: _____________________________________ Stove Inspected: Chimney Swept: Stove Inspected: Chimney Swept: Items Replaced: ____________________________________ Items Replaced: ____________________________________ © 2022 United States Stove Company...