Metabo HPT DH 40MEY2 Instructions De Sécurité Et Mode D'emploi page 6

English
SPECIFICATIONS
Motor
Power source
Current
Capacity
No-load speed
Full-load impact rate
Weight
APPLICATIONS
Rotation and hammering function
○ Drilling anchor holes
○ Drilling holes in concrete
Hammering only function
○ Crushing concrete, chipping, digging, and squaring
(Some applications need optional accessories)
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power source requirements specifi ed on the
product nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the
plug is connected to a receptacle while the switch is
in the ON position, the power tool will start operating
immediately and can cause serious injury.
3. Extension cord
When the work area is far away from the power source,
use an extension cord of suffi cient thickness and rated
capacity. The extension cord should be kept as short
as practicable.
WARNING
Damaged cord must be replaced
or repaired.
4. Check the receptacle
If the receptacle only loosely accepts the plug, the
receptacle must be repaired. Contact a licensed
electrician to make appropriate repairs.
If such a fautly receptacle is used, it may cause
overheating, resulting in a serious hazard.
5. Confi rming condition of the environment:
Confi rm that the work site is placed under appropriate
conditions conforming to prescribed precautions.
6
ASSEMBLY AND OPERATION
Brushless motor
Single-phase, 120 V 60 Hz
11.3 A
Drill bit: 1-9/16" (40 mm)
Core bit: 4-1/8" (105 mm)
250–500 /min
1,400–2,800 /min
15.0 lbs (6.8 kg)
6. Installing the Side Handle
(1) Turn the side handle to dismantle. (Fig. 2)
Band
Handle bolt
(2) Place the band over the band attachment area and fi t
the band's two holes onto the "T" portion of the handle
bolt. (Fig. 3, 4)
Band attachment area
Band
Mount
Side handle
Fig. 2
Fig. 3
Handle bolt
Fig. 4