Publicité
Les langues disponibles
Les langues disponibles
Switch
USING DRILL CHUCK, CHUCK ADAPTOR
Note that this machine can be used at "rotation only"
if separately sold parts such as drill chuck and chuck
adaptor are attached. Use it with the selector lever
Tool
positioned at "rotation + hammering".
WARNING
During operation, be sure to grip the handle and
the side handle fi rmly to prevent your body from
swaying.
(1) Switching to "rotation + hammering"
For switching to "rotation + hammering", follow the same
procedures mentioned in [3. When drilling at "rotation
+ hammering"] in Page 9.
(2) Attaching chuck adaptor to drill chuck (Fig. 19)
(a) Attach the chuck adaptor to the drill chuck.
(b) The SDS max shank of the chuck adaptor is
equivalent to the drill bit. Therefore, follow the
same procedure as [7. How to install tool] in
Page 7 for attaching and detaching.
SDS max shank
Drill
Chuck
chuck
adaptor
(3) Drilling
(a) Even if you apply more-than-required pressure to
the machine body, drilling can never be performed
as quickly as you expect. Applying more force
or pressure to the machine body than what is
needed, on the contrary, damages the drill tip,
resulting in the declined working effi ciency and
shortened life of this machine.
(b) A drill can snap sometimes when drilling is almost
fi nished. It is important to relax your thrusting
pressure when drilling is nearing the end.
Continuous
operation
button
LED
(Blue)
Fig. 18
Grip
Fig. 19
HOW TO USE THE CORE BIT
When boring penetrating large hole use the core bit. At
that time use with the center pin and the core bit shank
provided as optional accessories.
1.
Mounting
CAUTION
Be sure to turn power OFF and disconnect the
plug from the receptacle.
(1) Mount the core bit to the core bit shank. (Fig. 20)
Lubricate the thread of the core bit shank to facilitate
disassembly.
Core bit
(2) Mount the core bit shank to the Rotary Hammer.
(Fig. 21)
(3) Insert the center pin into the guide plate until it stops.
English
Core bit shank
Fig. 20
Fig. 21
11
Publicité
