Publicité
Les langues disponibles
Les langues disponibles
English
(2) Fixing working positions of tools such as cold chisel,
etc.,
(a) Turn the selector lever.
Align ▲ of the selector lever and
cover as illustrated in Fig. 14.
Selector lever
(b) Turn the the Grip or Tool as illustrated in Fig. 15
and fi x the tool to the desired working direction.
Tool
(c) Switch the selector lever to "hammering"
according to the procedures mentioned in the
above item (1) and secure the position of the tool.
5.
Install the stopper (Fig. 16)
(1) Loosen the wing bolt, and insert the stopper into the
mounting hole on the side handle.
(2) Adjust the stopper position according to the depth of
the hole and tighten the wing bolt securely.
Stopper
10
of the crank
Fig. 14
Grip
Fig. 15
Mounting hole
Wing bolt
Fig. 16
6.
Warming up (Fig. 17)
The grease lubrication system in this unit may require
warming up in cold regions.
Position the end of the bit so makes contact with the
concrete, turn on the switch and perform the warming
up operation. Make sure that a hitting sound is
produced and then use the unit.
CAUTION
When the warming up operation is performed,
hold the side handle and the main body securely
with both hands to maintain a secure grip and be
careful not to twist your body by the jammed drill
bit.
7.
Using the Continuous operation button
When operating this machine in " hammering" mode,
you can set it to remain ON after the switch is released
by pressing the Continuous operation button.
CAUTION
Never allow magnets (or similar magnetic devices)
to be adjacent tool body, because this product has
a magnetic sensor inside. Doing so will cause a
failure or risk of injury by malfunction.
Selector lever
Press the Continuous operation
button with the switch trigger
pulled back
(Blue LED will light up)
"hammering"
[To cancel Continuous operation]
Press the Continuous operation
button
Continuous operation button
"rotation +
cannot be used for this mode
hammering"
Fig. 17
Operation
Publicité
