Publicité
Les langues disponibles
Les langues disponibles
Installation (continued)
To use toggle bolts:
Spacing for Toggles
More Than Wall
Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
□
Place the mounting plate against the wall and insert the toggle
wings into the holes in the wall to mount the plate.
NOTE: Before tightening toggle bolts and wood screws,
make sure the bottom of the mounting plate touches the
bottom of the cabinet when pushed flush against the wall and
that the plate is properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers between the
back of the mounting plate and the wall.
□
Tighten all bolts. Pull the plate away from the wall to help tighten
the bolts.
C2. USING TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
□
You need to drill holes for the top support screws, a hole large
enough for the power cord to fit through, and a cutout large enough
for the exhaust adaptor.
□ Read the instructions on the TOP CABINET TEMPLATE.
□ Tape it underneath the top cabinet.
□ Drill the holes, following the instructions on the TOP CABINET
TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in the
cabinet bottom.
Bolt End
22
C3. ADAPTING MICROWAVE BLOWER FOR
OUTSIDE TOP EXHAUST
□
Place the microwave in its upright position, with the top of the
unit facing up.
□
Remove the screw that holds the blower plate to the microwave.
□
Remove and save the screwholding the blower motor to the
microwave.
□
Carefully pull out the blower unit. The wires will extend far
enough to allow you to adjust the blower unit.
End A
□
Roll the blower unit 90° so that fan blade openings are facing out
the top of the microwave.
Blower Plate
Back of
Microwave
Blower Motor
Screw
End B
Back of
Microwave
Publicité
