Publicité
Les langues disponibles
Les langues disponibles
Installation (continued)- C. Outside Top Exhaust (Vertical Duct)
INSTALLATION OVERVIEW
C1. Attach Mounting Plate to Wall
C2. Prepare Top Cabinet
C3. Adapting Microwave Blower for Outside Top Exhaust
C4. Check Damper Operation
C5. Mount Microwave Oven
C6. Adjust Exhaust Adaptor
C7. Connect Ductwork
T TO
NOTE: IT IS VERY IMPORTAN
THE DIRECTION S
READ AND FOLLOW
IN THE INSTALLAT ION
INSTRUCT IONS
NG WITH THIS
BEFORE PROCEEDI
.
REAR WALL TEMPLATE
serves to position the bottom
This Rear Wall Template
mounting plate and to locate
the horizontal exhaust
outlet.
that the template is positioned
1. Use a level to check
accurately.
one stud on the left or
2. Locate and mark at least
right side of the centerline.
least one wood
It is important to use at
a stud to support the weight
screw mounted firmly in
two additional, evenly spaced
of the microwave. Mark
locations for the supplied
toggle bolts.
locations. Where there is
3. Drill holes in the marked
for wood screws. For holes
a stud, drill a 3/16" hole
a stud, drill 5/8" holes for
that do not line up with
toggle bolts.
MOUNTING PLATE
DO NOT INSTALL THE
AT THIS TIME.
from the rear wall.
4. Remove the template
Instruction book for your
5. Review the Installation
installation situation.
Darle vuelta a la hoja para
consultar la
versión en Español.
to align with holes in the
Locate and mark holes
mounting plate.
IMPORTAN T:
STUD ON EITHER SIDE
OF
LOCATE AT LEAST ONE
THE CENTERLIN E.
FOR 2 ADDITIONA L,
EVENLY
MARK THE LOCATION
IN THE MOUNTING PLATE
SPACED TOGGLE BOLTS
AREA.
along the dotted line.
Trim the rear wall template
C1. ATTACHING THE MOUNTING PLATE TO THE
WALL
3/8" TO EDGE
along the dotted line.
Trim the rear wall template
12"
4"
to align with holes in the
Locate and mark holes
mounting plate.
IMPORTAN T:
OF
STUD ON EITHER SIDE
LOCATE AT LEAST ONE
THE CENTERLI NE.
FOR 2 ADDITIONA L,
EVENLY
MARK THE LOCATION
IN THE MOUNTING PLATE
SPACED TOGGLE BOLTS
AREA.
NOTE: Make sure the screws for the blower motor and
blower plate are securely tightened when they are reinstalled.
This will help to prevent excessive vibration.
NOTE: Make sure the motor wiring has been properly routed
and secured, and that the wires are not pinched.
□
Attach the plate to the wall using toggle bolts. At least one wood
screw must be used to attach the plate to a wall stud.
□
Remove the toggle wings from the bolts.
□
Insert the bolts into the mounting plate through the holes
designated to go into drywall and reattach the toggle wings to
3/4 in. (19 mm) onto each bolt.
21
Publicité
